Product Function 1. Set Temperature ---- SetT; 2. Backlash Temperature-----BackT; 3. Heating Mode "H": - When Temperature =< SetT - BackT; Relay conduction, heating equipment begin to work; - When Temperature =< SetT, Relay disconnect, heating equipment stop work; 4. Refrigeration mode "C": - When Temperature >= SetT + BackT ;Relay conduction, refrigeration equipment begin to work; - When Temperature =< SetT; Relay conduction, refrigeration equipment stop work; 5. High Temperature Alarm "ALA": - When Temperature >= Alarm Temperature, The system opens the sound and light alarm, and disconnects the relay, any key stops the sound light; 6. Delay Start "OPH": - When a normal heating or refrigeration work is done, the system starts to time T, and only after the T>=OPH, the system can carry out the next round of heating or refrigeration work; 7. Temperature Correction Function OFE(-10.0 ~ 10.0 degree C): - The system will work for a long time and may have deviations that can be corrected by this function, Temperature = Measured + Calibration; 8. Parameter Remote Read/Set: - The parameters such as setting temperature, backlash temperature and temperature correction can be set through UART. 9. Real-time Temperature Report: - If the temperature reporting function is turned on, the product is transmitted to the terminal by the UART at 1s intervals, which facilitates data collection; 10. Relay enable (default enable): - If the relay is disable, the relay remains disconnected; 11. Restore factory Settings: - At the same time press the STOP, set key more than 3S, restore factory settings;
Working mode setting /backlash temperature 1. In the running interface, short press SET key, enter the Quick setting interface; 2. After entering the Quick Setup interface, switch the parameters 3. Through the UP DOWN key, modify the parameter value, support short press/long press; 4. Long press SET to buil
